Description: Used to set whether this trunk group will allow calls to "passthrough" to an opposite trunk group if necessary. If you are configuring the PSTN trunk group and this option is set to yes, then calls that come in from the channels assigned to this trunk group will unconditionally "passthrough" to a PBX trunk group that has a matching pttrunkid (see command below). If in the above example, this option is set to no in a PSTN trunk group, then any calls that come in from channels assigned to this trunk group will look to route over the IP (if there is a match). If there is no match for the number, the call will be disconnected. If you are configuring the PBX trunk group and this option is set to yes, then calls that come in from the channels assigned to this trunk group will route to a PSTN trunk group if A) a match for the number is found in the Bypass table, B) no match is found for the number on the IP network or C) if the call routes over IP and does not get connected, the Tenor will try a PSTN trunk group as an alternate route. For the purposes of this section, the prompt will be shown as config pstntg 1# or config pbxtg 1#.
Cmd Type: command.
Prompt Level: config pstntg 1# and config pbxtg 1#
Syntax: passthru or pass {0 | 1}
Arguments:
0 No. This trunk group will not allow calls to pass-through to another TG.
1 Yes. This trunk group will allow calls to pass-through to another TG.
Default: 1 - Yes
Availability: All releases of Tenor units.
Guidelines: Typically this option is set to No for the Calling Card application at the remote agent ends, however, other applications may require a change in this.
Examples:
config pstntg 1# passthru 0
Sets the first PSTN trunk group passthru to No.
config pbxtg 1# passthru 0
Sets the first PBX trunk group passthru to No.
Related Cmds: pttrunkid