Tenor (tm) Survivable SIP Gateway (SSG) - S106-xx-xx Release Notes

This document lists open issues for the following products running software version S106-xx-x (SSG or "SIP Survivable Gateway"):

Analog Gateways

Tenor S AX
Tenor S AS
Tenor S AF

Digital Gateways

Tenor S BX
Tenor S DX
Tenor S DXi

Note: This document only addresses these products running survivability software (prefixed with an "S"), not standard gateway software (prefixed with a "P").

Upgrading to Tenor S Software from Standard Gateway Software

It should be noted that although the Tenor S (survivabilty) software runs on many of the same hardware platforms, it is a separate product with slightly different defaults for some parameters, and some new parameters that do not exist in the standard gateway software. With that in mind, it is best to restore factory defaults after upgrading to S106 software from P10x software. This will ensure proper defaults, good security and best operating behavior.

Also, note that a license upgrade is required to use survivable software. Survivable software (prefixed with an "S", such as S106) must not be run on a system without the proper license. It will not behave as expected if the proper license is not installed. Contact your distributor to obtain a license upgrade.

It is highly recommended that the Tenor S Application Guide be read and fully understood to ensure a seemless introduction to this product line.

Interoperability

The Tenor-S AX, Tenor-S AS, Tenor-S AF, Tenor-S BX, and Tenor-S DX running S106-xx-xx interoperate with Tenor Configuration Manager, CM106-01-00.

The SSG interoperates successfully with several IP PBXs and soft-switches, such as Avaya, Broadsoft and Asterisk.

The following proxies have incompatiability issues with the SSG: SER, Ondo and ININ.

See http://www.quintum.com/support for the latest changes in product interoperability or to download the latest code.