RadiusInfo Level - EndpointServer |
|
Description |
The EndpointServer prompt is for configuring the 2G Tenor to handle RADIUS-based endpoint authentication. |
|
Guidelines |
A properly configured RADIUS Server may provide a level of “access security,” by authenticating which devices are permitted to route calls to a particular place. |
|
Notes |
In order for these parameters to be configured, you must first enable EPRadiusAuthorization. This parameter can be found under GateKeeperParameters Prompt Commands (config gkp#). Use the following command to enable: config-GateKeeperParam-1# set epra 1 Also, you must configure the AccountingType parameter under RadiusInfoLevel - UserServer if you want to use RADIUS for accounting. |
|
Related Topics |
PrimaryAuthenticationPort or SecondaryAuthenticationPort PrimaryServerIPAddr or SecondaryServerIPAddr |
|
Location |
Systemwide Configuration > Radius Servers > Radius-EndpointServer |
|
Cmd Type |
Prompt |
|
Prompt Level |
config# |
|
Syntax |
ri endpointserver |
|
Examples |
Quintum-RadiusInfo-EndpointServer# show -a RadiusInfo-EndpointServer : PrimaryAuthenticationPort : 1812 default PrimaryServerIPAddr : 0.0.0.0 PrimaryACcountingPort : 1813 default SecondaryAuthenticationPort : 1812 default SecondaryServerIPAddr : 0.0.0.0 SecondaryACcountingPort : 1813 default RetryCount : 3 Retry Count,default Timeout : 5 5 seconds Time Out SharedSecret : <Not Set> Up to 63 chars IDType : 0 PasswordType : 0 |