DefaultANIPresentationInd

Description

All three of the settings for this command relate to the presentation indicator (CLIR bit) in the Calling Party Information Element in the outbound ISDN SETUP message. This bit tells the telco to suppress Caller ID. When the CLIR bit is set, the display of Caller ID is set to restricted presentation.

There is a command with the same name in the IPRG and ISDNSG. See the links below.

Guidelines

The SS7 Signaling Group prompt is only available for Tenor CMS, code version P103-00-00 or later.

Valid settings are as follows:

• 0 - Relay ANI from incoming leg of call (default).

• 1 - If no ANI is available the CLIR bit is set to restricted. When ANI is available, use the value from the incoming leg.

• 2 - If ANI is present, send it with CLIR bit set to restricted. If ANI is not available, set CLIR bit to restricted.

Related Topics

SS7SignalingGroup-1 (ss7sg 1) Prompt Commands

DefaultANIScreenInd - SS7 Signaling Group

DefaultANIPresentationInd - ISDN Signaling Group

DefaultANIPresentationInd - IP Routing Group

Location

Circuit Configuration > Signaling Configuration > SS7 Signaling Groups > SS7 Signaling Group-n > Default ANI Presentation Indicator

Options

Select from the drop-down box. Options are as follows:

• Relay ANI

• Set CLIR if no ANI; else Relay ANI

• Always Set CLIR and Relay ANI

Cmd Type

Command

Prompt Level

config-SS7SignalingGroup-1# 

Syntax

set defaultanipresentationind ordanipi { 0 | 1 | 2 }

Arguments

0   Relay ANI from incoming leg of call.

1   If no ANI is available the CLIR bit is set to restricted. When ANI is available, use the value from the incoming leg.

2   If ANI is present, send it with CLIR bit set to restricted. If ANI is not available, set CLIR bit to restricted.

Default

0   RelayANI from incoming leg

Examples

config-SS7SignalingGroup-1# set danipi 2

Sets the CLIR bit to restricted.